Home additions & ADU
Kitchen remodeling
Bathroom remodeling
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Sakrete Home Additions & ADU: The Lancaster Owner’s Guide
We build and finish home additions and ADUs in Lancaster using Sakrete concrete and mortar products, and a typical addition runs $45,000 – $130,000 installed, while a full ADU lands between $90,000 and $220,000. That’s a wide range because the foundation, the slab, and the finish work are three different conversations. Most owners don’t wake up thinking about Sakrete. They start asking about it when a porch slab heaves, a footing cracks at the corner of an old addition, or mortar joints in a block stem wall start crumbling after a dry summer. Sakrete is the bag on the pallet, not the part that failed. The failure is almost always in how the mix was placed, cured, or tied to the structure above it, and that’s the part we can actually diagnose.
Which Sakrete Models This Applies To
Sakrete isn’t a single product. For addition and ADU work in Lancaster, the bag you’re looking at is usually one of a few: High-Strength Concrete Mix, Crack-Resistant Concrete, Mortar Mix (Type N or Type S), Sand Mix, or Fast-Setting Concrete for post and pier work. Each has a different compressive strength rating printed right on the bag, and each is meant for a different job. Type N mortar is for above-grade block; Type S is for load-bearing walls; sand mix is for topping and patching, not structural footings. Mixing them up is the most common compatibility mistake we see.
How to identify what you have: find the bag, read the strength rating and the model name, and measure the pour area. If the bag is gone, we look at the surface. Fast-setting mixes leave a smoother, denser face than standard concrete. High-strength pours ring harder when tapped. If you’re pricing a repair, note the pour date. Concrete in the Antelope Valley cures differently in July than in January, and that matters for whether a patch will bond or fail again.
OEM versus aftermarket is simpler here than it sounds. Sakrete is the brand most lumber yards and hardware stores in Lancaster stock, so matching a mix is easy. Where owners get burned is buying the wrong formulation because it was on sale. We don’t carry Sakrete stock, and we don’t claim to. We source the correct product for the pour and quote it as a line item. If you want a brand read on cabinet and countertop finishes for the addition’s interior, we also handle KraftMaid, Cambria, and Silestone.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Sakrete Home Additions & ADU Is Failing
- Hairline cracks spreading from a corner or footing. Usually shrinkage from a pour that cured too fast in Lancaster heat. If the crack is wider than a credit card, it needs a look.
- Crumbling mortar joints in block or brick. Often Type N used where Type S was specified, or a mix that sat too long before placement. Repointing is the fix, not a skim coat.
- Heaving or dipping porch and patio slabs. The Antelope Valley’s swing between hot days and cold nights moves slabs that weren’t isolated from the structure. This shows up as a lip at the doorway.
- Chalky, dusty concrete surfaces. Overworking the finish or too much water in the mix brings weak material to the top. It will keep dusting until it’s sealed or resurfaced.
- Separation between an addition slab and the original house. A missing or failed isolation joint. This one is structural, and it’s worth a call before you pour anything over it.
Replacement Cost & What’s Included
For Lancaster, our installed addition pricing starts at $45,000 and runs to $130,000 depending on square footage, foundation type, and finishes. ADU construction runs $90,000 – $220,000. Garage conversions, which are the most common ADU path here, run $30,000 – $80,000. The Sakrete portion is a line item inside that: a high-strength footing or slab pour typically sits between $1,200 and $4,500 of the total, depending on area and access.
What drives the range: soil prep, rebar, form work, pump or wheelbarrow access, cure time, and whether permits trigger a soils report. Every scope and every allowance arrives in writing before work happens. If a footing turns out to need more concrete than quoted, that’s a written change order before the truck rolls, not a surprise invoice at the end. Every eligible job gets permits pulled and inspections signed, and the finished work is backed by the written 90-Day Done Right Promise.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
You can safely read a bag label, measure a pour, and photograph a crack. You can also seal a dusty slab or repoint a small joint. Where DIY goes wrong on additions and ADUs is the load path. A footing that carries an addition wall is not a patch job, and a slab poured against the house without a proper isolation joint will fail again in one Lancaster summer-to-winter cycle. Concrete doesn’t forgive a bad mix ratio, and it doesn’t tell you it’s wrong until it’s cured. If the pour touches the structure of your home, get it looked at. Call (888) 427-1810 and we’ll come out, put eyes on it, and tell you honestly whether it’s a patch or a pour.
Fast facts: Barrett & Sons Construction is an independent contractor and is not affiliated with Sakrete. Our technicians have up to 28 years of experience. We’re owner-operated, and every eligible job is permitted and inspected.
FAQs
A properly mixed, properly cured Sakrete pour should last 30 to 50 years in Antelope Valley conditions. The two things that shorten that: pouring in extreme heat without slowing the cure, and skipping a control joint. Call (888) 427-1810 if you want an honest read on an existing slab.
Sometimes yes. Hairline shrinkage cracks and dusty surfaces can be sealed or resurfaced. Heaving, structural cracks, or a footing that’s separated from the house usually can’t be patched reliably. We’ll tell you which one you’re looking at before you spend a dime.
The Sakrete concrete portion of a typical addition is usually 2 to 5 days of actual work, plus cure time before framing. The full addition timeline is weeks, not days. We’ll give you a written schedule with your estimate so you know what to expect each week.
We match the mix to the pour: High-Strength for footings, Type S for load-bearing block, sand mix for topping only. We don’t stock parts and we don’t claim to. We buy the correct product for your job and quote it as a written line item.
Ready to Get a Real Number?
If you’re in Lancaster and looking at a cracked footing, a dusty slab, or you’re ready to plan an addition or ADU, call (888) 427-1810 for a free estimate. You’ll get a written scope, written allowances, and written change orders before any work starts. Ask us about the $40 Off Any Repair Over $200, the Free Second Opinion on Any Written Estimate, no trip charge inside the county, and the permanent 10% Senior & Veteran discount. A live person answers the phone, 24 hours a day.
Written by the team at Barrett & Sons Construction Lancaster, serving Lancaster and nearby areas.