Fence
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & paversFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Oldcastle Fence Installation: The Lancaster Owner’s Guide
Installing a new fence on a Lancaster property with Oldcastle materials typically runs $3500 – $9000 for a standard residential yard, and scheduled installation usually takes one to three working days once materials arrive. We install Oldcastle-compatible fencing and we don’t claim same-day turnaround on new fence builds – this is planned work, not an emergency repair. Most Lancaster owners discover they need this when a section leans after a wind event on the west side, when posts start rocking in the caliche-hard soil, or when they’re replacing a failing wood or chain-link run and want a clean, permitted replacement that will hold up. We schedule estimates within a few days and installation within one to two weeks of a signed contract and permit.
Which Oldcastle Models This Applies To
Oldcastle makes several fence families under its regional brands, and the panels are not interchangeable between them. The most common residential lines are vinyl privacy panel systems, ornamental aluminum picket, and chain-link with coated components. You need to identify the actual system before ordering anything, because a 6-foot panel from one line will not mate with posts from another – the rail channel widths and post caps differ by a fraction of an inch that doesn’t sound like much until you’re staring at a gap.
Look for the manufacturer label on the gate latch side of a panel or on the inside face of a post. If the label is gone, measure the panel face width and the post cross-section. Standard vinyl privacy systems run 6 to 8 feet wide per panel with a 5×5 or 4×4 post; ornamental aluminum usually sits at 6-foot panel widths with square or fluted posts in the 2-inch to 3-inch range. Bring those two measurements to us and we can tell you which Oldcastle line you’re dealing with.
The OEM-vs-aftermarket call matters here. Oldcastle-branded components cost more but match exactly. Quality aftermarket equivalents for rails, caps, and brackets fit specific lines and often do the job fine, especially on non-structural pieces. For posts and gates, we strongly recommend staying with the matched system – a post that’s slightly off-spec is where fence failures start. Note that Barrett & Sons Construction Lancaster is an independent installer, not affiliated with Oldcastle or any of its brands.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Oldcastle Fence Installation Is Failing
- Leaning posts after a wind event. Antelope Valley gusts in the 30 to 50 mph range punish any post that wasn’t set deep enough or in properly compacted soil. If a post rocks when you push it, the footing is compromised.
- Rails separating from posts at the brackets. This is almost always a fastener issue – screws backing out in thermal cycling, or brackets installed without the specified anchor. Our daytime highs swing 30 to 40 degrees between summer and winter, and vinyl expands and contracts with every swing.
- Cracked or discolored vinyl panels. Oldcastle vinyl holds up to UV well, but panels installed too tight against posts will crack at the rail insertion points over time as expansion has nowhere to go.
- Gate sagging or dragging. Usually a hinge or latch wear item, occasionally a sign the gate post has shifted. Don’t ignore it – a dragging gate stresses the whole post.
- Rust streaks on ornamental aluminum gates or chain-link posts. Coating failure at ground line or at cut ends. If the steel is exposed and eating through, replacement beats patching.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Fence installation in Lancaster runs $3500 – $9000 for a standard residential job. The range depends on linear feet, material (vinyl at the low to middle, ornamental aluminum at the higher end), gate count, terrain, and whether old fence removal is included. A typical 100 to 150 linear foot vinyl privacy run with one gate lands in the middle of that range; aluminum or a larger lot pushes toward the top.
Every quote we write is line-item: materials by brand and system, post footings, gates, old fence removal, permit fees where the city requires them, and labor. Every scope and every allowance is in writing, and any change order arrives in writing before we touch the job. No surprise invoices at the end – the allowance that isn’t on paper is a surprise waiting for a date, as Tom says. The work is backed by the written 90-Day Done Right Promise.
DIY or Call Us?
An owner can safely check a few things. Walk the fence line and push each post – any movement means the footing is bad. Inspect brackets and rails for backed-out screws. Read the manufacturer label. Measure your panels and posts. That’s information that makes a quote faster and more accurate.
What goes wrong with DIY here: post depth and soil compaction. Lancaster’s caliche and hardpan need proper footing prep – auger through the hard layer, set the post below frost line, and compact with the right gravel mix. A post set too shallow looks fine on install day and leans after the first Santa Ana wind, and by then you’ve dug and poured twice. If your fence includes any height work near power lines or requires a permit, that’s a call-us job. On older Lancaster properties, buried irrigation or gas line locations also matter – that’s a safety call before the first auger turns.
Call (888) 427-1810 to schedule a free estimate. A live person answers 24 hours a day. We don’t have a truck stocked with parts and we don’t claim same-day – we source your Oldcastle line through our materials network, confirm the match with you, and install it right.
FAQs
How long does an Oldcastle vinyl fence last in Lancaster? A properly installed Oldcastle vinyl privacy fence typically lasts 20 to 30 years in Antelope Valley conditions. The sun is the main enemy, not rain. UV-stabilized vinyl holds color well but will fade slightly over the decades, and posts set in bad soil fail well before the panels do.
Can I repair instead of replacing? Often, yes. A single leaning post, a cracked panel, a sagging gate, or worn brackets can be swapped without replacing the run. Repairs over $200 qualify for the $40 off any repair offer. We’ll tell you honestly whether a repair buys you years or just months. Call (888) 427-1810.
How long does the swap take once we start? Most residential fence installs finish in one to three working days. Prep, footing cure time, and gate hanging add a day in some cases. Permits, where the city requires them, add time before the start date – we pull them, and the permit inspector works for you, not for us.
How do you source the right Oldcastle part? We match your system by label or by measurement – panel width and post cross-section – then source through our materials network. You’ll see the specific system name on your written quote before you sign. We also install brands like KraftMaid, Cambria, and Silestone on the kitchen side, so we know how to match a manufacturer’s specification across the trades we work in.
Barrett & Sons is owner-operated, and Tom Barrett publishes his name, address, and license number for anyone who wants to look it up before signing anything. Serving Lancaster and the surrounding high desert communities, we sit twenty minutes away – if something’s wrong, we want to know about it.
Call (888) 427-1810 for a free estimate on your Oldcastle fence installation in Lancaster. Standing offers include a $40 discount on any repair over $200, a free second opinion on any written estimate, no trip charge inside the county, and a permanent 10% senior and veteran discount.
Written by the team at Barrett & Sons Construction Lancaster.