Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Oldcastle Driveway & Pavers: The Lancaster Owner’s Guide
We install Oldcastle driveway and paver systems built to the same spec as what’s sold across Lancaster, and most full paver driveways here land between $7,000 and $18,000 installed, with resealing running $250 – $700 and single-area paver patio work $3,500 – $11,000. Barrett & Sons Construction is an independent contractor and not affiliated with Oldcastle. When an Oldcastle system starts failing, Antelope Valley homeowners usually spot it the same way: a hairline crack that spreads across a paver face after the first hard freeze, a rut at the driveway apron where tires cross the transition, or base sand washing out from under the edge restraint after a windy spring. We fix what’s underneath the pavers first, then set the surface back the way it was meant to sit.
Which Oldcastle Models This Applies To
Oldcastle makes a deep catalog of concrete pavers, retaining wall block, and segmental driveway systems, and the part that matters changes with the product. The company’s standard 60mm and 2 3/8-inch thick paving stones are the most common ones we pull and reset in Lancaster, and they’re typically identified by a pallet label, a mold stamp on the underside of a loose unit, or a paper spec sheet tucked in the homeowner’s file from the original install. If the label is gone, we measure a full unit in length, width, and height to match it to the closest current series, because a 6×9 paver and an 8×8 paver aren’t interchangeable once mortar or interlock is in play.
OEM Oldcastle pavers are the cleanest match for color and thickness when you’re patching a small area, but they’re not always worth hunting down if the pattern hides the seam. A quality aftermarket concrete paver in a compatible thickness often installs at a lower cost and lasts the same when the base is built right. The decision usually comes down to whether the new units are visible from the street and how tight the color match needs to be.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Oldcastle Driveway & Pavers Is Failing
Most of what goes wrong with an Oldcastle paver driveway in Lancaster traces back to the base, the edge restraint, or the freeze-thaw cycle in the high desert rather than the paver itself. Here’s what homeowners call us about:
- Spalling or surface flaking. The top face of a paver chips or flakes away in thin layers. Usually caused by freeze-thaw cycling when moisture trapped in the concrete expands overnight, and the Antelope Valley’s cold winter mornings accelerate it.
- Sunken or rutted areas. The pavers settle lower in the tire tracks. That’s base compaction failure – the aggregate underneath wasn’t compacted in lifts or was too thin to begin with.
- Edge restraint pushing outward. The perimeter of the driveway heaves or the edging separates. Frost, root pressure, or an undersized edge restraint lets the field move.
- Loose sand washing out. Joint sand disappears after wind or a rain event. The sand is what locks the units together; when it’s gone, pavers shift.
- Cracks in individual pavers. A paver splits through the middle. That’s usually a point load on a hollow spot or a paver laid over a soft subgrade.
Any two of those together tell you the failure isn’t cosmetic. The surface is telling you the base or restraint needs attention, and re-laying pavers over a bad base just delays the next failure.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s what Oldcastle-compatible driveway and paver work runs in Lancaster, with the labor, base prep, and joint sand folded into each range:
| Work | Installed range |
|---|---|
| Paver driveway installation | $7,000 – $18,000 |
| Paver patio installation | $3,500 – $11,000 |
| Driveway replacement | $5,000 – $14,000 |
| Driveway sealing | $250 – $700 |
| Concrete driveway installation | $4,500 – $12,000 |
Where a job lands in that range depends on square footage, how much base has to be excavated and re-compacted, whether the old pavers are salvageable, and how much edge restraint needs replacing. We quote parts and labor as separate lines on every estimate, so you can see exactly what the pavers cost versus the base work. Every price change arrives as a written change order before it touches the job. Roof, fence, and window work typically runs through other brands, but if you’ve got a KraftMaid, Cambria, or Silestone job alongside the driveway, we can fold that into the same written scope. Our completed work carries the 90-Day Done Right Promise on every contract.
DIY or Call Us?
If the only issue is missing joint sand or a single loose paver at the edge, an owner can safely sweep sand back into the joints and lift one unit by hand. That’s about where it stops. Re-setting a failed paver field means breaking the edge restraint, digging out compacted base by hand, and re-compacting in 2-inch lifts with a plate compactor most homeowners don’t own. Trying to fix a settled area by dumping sand on top just kicks the problem down the road and often makes the grading worse. This isn’t dangerous like a spring under tension, but it’s easy to make a $7,000 driveway worse by skipping base prep. If you’ve got a sunken section, a spreading crack, or an edge that’s pushing out, call (888) 427-1810 and we’ll come look and tell you honestly what’s worth fixing.
FAQs
An Oldcastle paver driveway with a properly compacted base and a solid edge restraint will typically last 25 to 30 years here, and often longer. The pavers themselves rarely fail first; the base is what determines the lifespan, and the high desert freeze-thaw cycle punishes a base that’s too thin or under-compacted. Call (888) 427-1810 for a free estimate on your driveway.
Yes, most of the time. A localized failure – a single sunken spot, a few cracked units, an edge restraint that’s pulling away – can be repaired by lifting the affected area, re-compacting the base, and resetting the pavers. Full replacement only makes sense when the base has failed across the whole driveway. Call (888) 427-1810 and we’ll tell you which one you’re looking at before you spend anything.
A small repair runs a day or two, while a full paver driveway install or replacement typically takes three to five days depending on square footage and base excavation. Weather stretches that timeline in Lancaster, since wet ground won’t compact properly. Call (888) 427-1810 to schedule your free estimate and get a firm timeline.
We source from Oldcastle’s current product lines and match the closest series by measuring an original unit’s length, width, and thickness, then checking color and face pattern against the existing field. We don’t claim to stock parts or carry them on a truck – we pull the match to your job, and we’ll show you the unit next to the old one before we set anything. Call (888) 427-1810 for an exact quote; estimates are free.
Written by the team at Barrett & Sons Construction Lancaster, serving Lancaster and nearby areas.