Bathroom remodeling
Kitchen remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
KraftMaid Bathroom Remodeling: The Lancaster Owner’s Guide
We install KraftMaid bathroom cabinetry and vanities for Lancaster homeowners, and a full KraftMaid bathroom remodel here typically runs $9,000 to $28,000 installed, depending on layout, cabinet count and finish. This page exists because the most common call we get isn’t about a whole new room. It’s about one failed piece on a KraftMaid vanity, linen cabinet or bath surround that the owner can’t find a replacement for. KraftMaid door hinges, drawer glides and cabinet boxes come in series-specific sizes, so the “standard” part from a big-box store usually doesn’t match. Barrett & Sons Construction Lancaster is an independent service provider, not affiliated with KraftMaid.
Key Takeaways
- KraftMaid vanity and bath cabinet parts are series-specific. Measure and identify the line before you buy anything.
- Installed KraftMaid bathroom remodels in Lancaster run $9,000 to $28,000; a single vanity replacement is $800 to $3,000.
- Hinges and glides are the first failures, usually after 12 to 18 years of Antelope Valley heat and dry air.
- We pull the permit and get inspections signed on every eligible bath job.
Which KraftMaid Models This Applies To
KraftMaid builds bath and kitchen cabinetry across several lines, and the door style tells you little about the hardware underneath. Two cabinets that look identical from the kitchen table can carry different hinge patterns, box depths and drawer-glide systems. That’s the gotcha: the part number lives on the cabinet, not on the catalog page.
Before you order anything, look for the KraftMaid label on the inside of the cabinet box or on the back of a drawer. It carries the series and finish, and it’s the first thing a parts counter needs. Measure the door overlay (how far the door sits past the cabinet face), the hinge cup bore, and the drawer box width and depth. If you can’t find a label, those measurements usually identify the part.
On the OEM question: for hinges, drawer glides and shelf clips, the genuine KraftMaid part is the safe answer because the mounting holes line up without drilling. Quality aftermarket equivalents exist and often cost less, but only when the screw pattern matches exactly. We’ll compare both and tell you which one we’d put in our own home. The brands we also install and service include Cambria, Silestone and Kohler.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your KraftMaid Bathroom Remodeling Is Failing
- A door that sags or rubs the frame. The hinge screws have pulled loose from the particleboard or the hinge plate has worn. Once the wood is stripped, tightening the screw only buys you a month.
- Doors that swing shut on their own. The self-closing spring in the hinge has lost tension. Common in bathrooms where the door gets steamed daily and the cabinet stays closed.
- A drawer that sticks or drops one corner. The glide wheel or the track underneath has worn flat. In Lancaster, dry heat and a lightly loaded bathroom drawer speed this up.
- Peeling finish or swelling around the sink base. Moisture has reached the cabinet box, not just the door face. This one means the box itself may need replacing, not just a part.
- Soft or sagging shelf bottoms. Shelf pins have failed or the shelf board has taken on water weight. Left alone, the shelf drops and takes the contents with it.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s what these jobs run in Lancaster, installed, including parts and labor:
| Job | Installed Range in Lancaster |
|---|---|
| Full KraftMaid bathroom remodel | $9,000 – $28,000 |
| Small bathroom remodel | $5,000 – $12,000 |
| Bathroom vanity installation | $800 – $3,000 |
| Hinge or glide swap (single cabinet) | Quoted with the part, usually a repair visit |
| Walk-in shower installation | $4,500 – $12,000 |
| Tub-to-shower conversion | $3,500 – $10,000 |
The range swings on cabinet count, whether the layout changes, finish options, and whether the plumbing and electrical need to move. A vanity with the plumbing staying put lands near the low end. A tub-to-shower conversion with a new valve and tile lands near the top. What doesn’t swing: every scope, every allowance and every price change is written down and signed before we start. No surprise invoice at the end. Our technicians have up to 28 years of experience, and every completed job carries our written 90-Day Done Right Promise. Permits get pulled and inspections signed on every eligible bath job.
DIY or Call Us?
You can safely check a few things yourself. Look for the KraftMaid label inside the cabinet, measure the overlay and hinge bore, tighten a loose screw, and clean the drawer track. That’s useful information to have before you call anyone.
Where DIY goes wrong: swapping a hinge with the wrong bore or screw pattern, forcing a glide that doesn’t seat, or replacing a sink base and finding the plumbing no longer lines up. A bathroom cabinet sits over water and drain lines, and a cabinet that leaks behind the base does real damage to the floor underneath. If the box itself is soft or swollen, stop there and get eyes on it. Call (888) 427-1810 and we’ll tell you whether you need a part or a whole vanity. No trip charge inside the county, and estimates are free.
FAQs
Expect 20 to 30 years from the cabinet boxes, hinges and glides with normal use. Finish and hardware often fail first, and in Lancaster the dry climate actually helps cabinetry survive better than in humid coastal towns, so a failing hinge at year 15 is usually use, not climate. Call (888) 427-1810 for an exact quote on replacement, and estimates are free.
Yes, if the cabinet wood is still solid where the screws sit. A hinge swap or a glide replacement is a quick, low-cost repair and stays backed by our written 90-Day Done Right Promise. If the particleboard has crumbled around the mounting holes, a new part won’t hold and the door or drawer needs a different fix. Call (888) 427-1810 to schedule a free estimate.
A single vanity replacement usually takes a day to a day and a half once the cabinet and top are in hand, and a full bathroom remodel runs two to four weeks. Timeline depends on lead time for the KraftMaid finish and door style you choose, so we confirm the schedule in writing before work begins. Call (888) 427-1810 to schedule your free estimate.
We identify the series from the label inside the cabinet and order the matching KraftMaid hardware or equivalent part. We don’t carry parts on a truck and don’t claim to stock them. If a genuine part is discontinued, we’ll show you the quality aftermarket option and compare the screw pattern before anything gets drilled. Call (888) 427-1810 for a free second opinion on any written estimate you’ve already got.
Whether your KraftMaid bathroom needs a hinge, a vanity or a full rebuild, the answer starts with a free, no-pressure estimate. We’re owner-operated, we pull the permits, and every price change arrives in writing before a nail moves. Call (888) 427-1810 today to schedule your free estimate in Lancaster. Ask about our standing offers: $40 off any repair over $200, a free second opinion on any written estimate, no trip charge inside the county, and a permanent 10% Senior & Veteran discount.
Written by the team at Barrett & Sons Construction Lancaster, serving Lancaster and nearby areas.