A Barrett company - serving Lancaster, CA

Ameristar Home Additions & ADU in Lancaster, CA

Home additions & ADUHome additions & ADU
Kitchen remodelingKitchen remodeling
Bathroom remodelingBathroom remodeling
RoofingRoofing
Windows & doorsWindows & doors
Driveway & paversDriveway & pavers
FenceFence
Every visit starts with

Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled

We have financing partners for your dream remodel*On approved credit; ask us about your options
Get your free estimate

Ameristar Home Additions & ADU: The Lancaster Owner’s Guide

We build Ameristar-compatible home additions and ADU work in Lancaster, and a full addition typically runs $45,000 to $130,000 installed, while a detached or attached ADU lands between $90,000 and $220,000 depending on size and finish. A garage conversion sits in the $30,000 to $80,000 range. The honest part: when a homeowner starts researching “Ameristar parts” for an addition, what has usually failed is not a single part at all. It’s a foundation, a wall connection, a roofline tie-in, or a window or door unit that was installed at the edge of its spec and is now letting in Lancaster’s wind-driven dust and summer heat.

Call (888) 427-1810

Barrett & Sons Construction Lancaster is an independent service provider. We are not affiliated with Ameristar, and we don’t sell Ameristar parts as a dealer. What we do is match the right component to what’s actually on your house, pull the permit, and do the work in writing.

Key Takeaways

  • Ameristar additions in Lancaster run $45,000 to $130,000 installed; ADUs run $90,000 to $220,000.
  • Most “failed part” calls turn out to be installation detailing, not defective Ameristar material.
  • We write every scope, allowance, and price change down before work starts.
  • Our crew members have up to 28 years of experience with addition and ADU framing and tie-ins.

Which Ameristar Models This Applies To

Ameristar makes modular and panelized addition and ADU systems, and the part number that matters depends on the model line, panel series, and the year the unit was engineered. Before we quote anything, we want three things:

  • The data plate. Ameristar units carry an identification label, usually in a utility area, on a wall panel edge, or inside the electrical panel cover. It lists the model, serial, and engineering series.
  • Field measurements. We measure the actual opening, wall thickness, and span. Ameristar panel joints and connector plates are dimensioned to the series, and a plate cut to fit a different series will not seat correctly even if it looks close.
  • Existing permit records. The original permit from the City of Lancaster or LA County tells us what was approved, and that record is often the fastest way to confirm what’s really on your property.

One compatibility gotcha worth knowing: Ameristar hardware and connector kits are not universal across panel series or across production years, and a connector plate that fits a current series panel won’t necessarily seat on a unit built a decade earlier. Skipping the data plate and grabbing a “looks the same” part is how a small fix turns into a framing repair.

On OEM versus aftermarket: for structural connectors, sealed window and door units, and anything load-bearing, we specify OEM or an engineer-approved equivalent. For trim, flashing, and finish components, a quality aftermarket equivalent is often better and cheaper, and we’ll tell you which is which. We don’t claim to stock Ameristar parts or carry them on a truck; we source them to spec.

Explore

Styles & brands we work with

  • Kitchen remodeling
  • Bathroom remodeling
  • Home additions & ADU
  • Roofing
  • Windows & doors
  • Driveway & pavers
  • Fence

Signs Your Ameristar Home Additions & ADU Is Failing

Lancaster is high desert: dry air most of the year, brutal summer sun, and wind that can push fine dust into any gap that isn’t sealed properly. That climate punishes a detail that was rushed. Here’s what we actually see.

  • Dust and grit along panel seams and baseboards. This usually means a panel joint or weather seal has opened up, often because the original connection wasn’t sealed with the right gasket for desert conditions.
  • A door or window in the addition that won’t close true. The underlying cause is rarely the door. It’s usually a floor or wall movement from a footing that wasn’t detailed for Lancaster’s expansive soils.
  • Interior cracks radiating from panel corners or openings. These point to differential movement between the addition and the main house, or to a connector plate that’s loosened over time.
  • Roof-to-wall separation or a water stain on an interior ceiling plane. This means a flashing detail failed, and it’s the one symptom to address before the next rainy season.
  • Hot or cold rooms at the far end of the addition. Often an insulation or duct issue at the tie-in, not a failed Ameristar component, but the result is a room nobody wants to use.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Replacement Cost & What’s Included

Here’s what repair and rebuild work on Ameristar-compatible additions runs in Lancaster, installed:

Work Installed Range (Lancaster)
Home Addition (full build or rebuild) $45,000 – $130,000
ADU Construction $90,000 – $220,000
Garage Conversion $30,000 – $80,000
Panel/wall connector or seam repair Quoted per scope after inspection
Window or door unit replacement in an addition $4,500 – $15,000 (multiple units)

What drives the range is size, foundation conditions, whether we’re tying into an existing structure or building new, and finish level. We write every scope, every allowance, and every price change down before work happens, so there’s no surprise invoice at the end.

Every eligible job gets permits pulled and inspections signed. Every completed job is backed by our written 90-Day Done Right Promise.

DIY or Call Us?

You can safely do a handful of things: find and photograph the Ameristar data plate, note the model and serial, check your interior seams for dust and your ceilings for stains, and pull your original permit records from the city.

Where DIY goes sideways: anything structural or water-related on an addition. Re-seating a panel connector, correcting a footing-driven door issue, or chasing a flashing leak without an engineer’s read on the load path can turn a small repair into a five-figure rebuild. The foundation question alone needs a trained eye. Our crew members have up to 28 years of experience with these tie-ins, and we’ll tell you straight which parts you can safely handle and which need a permit and a pro.

Call (888) 427-1810 for a free estimate.

FAQs

Need Construction help nationwide? Licensed & insured · free written estimates
Call (888) 427-1810
Local Service Coverage

Request a Free Estimate in Lancaster

Tell us what you need - Barrett & Sons Construction Lancaster responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Send a Text
Call Now - 24/7 Dispatch