A Barrett company - serving Lancaster, CA

Tamko Bathroom Remodeling in Lancaster, CA

Bathroom remodelingBathroom remodeling
Kitchen remodelingKitchen remodeling
Home additions & ADUHome additions & ADU
RoofingRoofing
Windows & doorsWindows & doors
Driveway & paversDriveway & pavers
FenceFence
Every visit starts with

Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled

We have financing partners for your dream remodel*On approved credit; ask us about your options
Get your free estimate

Tamko Bathroom Remodeling: The Lancaster Owner’s Guide

We install bathroom remodeling with Tamko-compatible materials, and a full bathroom remodel in Lancaster typically runs $9,000 – $28,000 installed, depending on square footage, tile, and whether we’re moving plumbing. If a specific Tamko part has failed on you, we source the matching replacement and schedule the repair around your week – not the other way around.

Call (888) 427-1810

Owners usually find the problem the slow way. A mildew smell that comes back after every cleaning. Caulk lines that open up within a season. Grout that crumbles at the shower pan while the rest of the floor looks fine. In Lancaster’s high-desert climate – dry air most of the year, then a hard winter rain cycle and summer temps that push past 105°F – sealants and moisture barriers take a beating, and the failure shows up at the edges first: the curb, the corners, the window surround, the base of the wall behind the vanity.

Which Tamko Models This Applies To

Tamko’s residential line covers waterproofing membranes, underlayments, primers, and the accessory parts that hold a wet area together, and the part number matters more than the name on the box. A Tamko membrane sold for a tub surround is not the same thickness or fleece backing as the sheet specified for a curbless walk-in shower with a linear drain, and mixing them is one of the most common install errors we’re called to correct in Lancaster. Pull the label off the roll or the bucket and read the full spec line – series, thickness in mils, and the coverage figure. That’s the number to match.

Some Tamko accessories were revised across production runs, and an older roll may not match the current primer or bonding adhesive the installation calls for. If your label is faded or gone, measure the thickness with a caliper and photograph the substrate it was set over; that tells us more than a guess at the model name. On the OEM-versus-aftermarket question: for waterproofing and adhesives, stay with the specified Tamko part or a manufacturer-approved equivalent. The few dollars saved on an off-brand membrane isn’t worth a failed pan inspection. We’re an independent contractor and not affiliated with Tamko – we specify and install their products, and we tell you plainly when a part number doesn’t line up.

Explore

Styles & brands we work with

  • Kitchen remodeling
  • Bathroom remodeling
  • Home additions & ADU
  • Roofing
  • Windows & doors
  • Driveway & pavers
  • Fence

Signs Your Tamko Bathroom Remodeling Is Failing

Here’s what a failing membrane, sealant, or underlayment actually looks like before it turns into a floor replacement:

  • Recurring mildew at the shower corners and curb. Water is getting behind the tile or under the pan edge, and the membrane is either breached or was never lapped correctly. The smell returns because the moisture source never went away.
  • Grout that cracks and crumbles in one zone only. A localized grout failure usually means movement or a soft substrate under the tile, not bad grout. The underlayment has likely lost bond.
  • Caulk joints that pull open within a season. In Lancaster, the swing between dry winter air and summer heat cycles sealant hard. If new caulk fails fast, the joint behind it is moving.
  • Soft or spongy spots in the floor near the tub or shower. That’s moisture reaching the subfloor. By the time you feel it, the underlayment has usually been compromised for a while.
  • Staining or bubbling paint on the wall behind the shower or vanity. Water is wicking through the wall assembly. This one is worth a look now rather than later, because it often reaches framing.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Replacement Cost & What’s Included

For Lancaster, a full bathroom remodel runs $9,000 – $28,000; a small bathroom remodel runs $5,000 – $12,000; a walk-in shower installation runs $4,500 – $12,000; a tub-to-shower conversion runs $3,500 – $10,000; and a shower replacement alone runs $3,000 – $8,500. A vanity installation is $800 – $3,000 if that’s the piece you’re replacing.

What moves the number: whether we’re tearing out to the studs or working over sound existing substrate, tile selection, drain relocation, and whether the permit pulls an inspection. Every quote is line-itemed – materials, labor, and allowances – and any change after that arrives as a written change order before we touch the wall. Permits get pulled and inspections signed on every eligible job. The work is backed by our written 90-Day Done Right Promise: if something isn’t right, one call brings Tom back.

DIY or Call Us?

You can safely check a few things yourself: look for soft spots in the floor, press on tile edges to feel for hollow spots, check the caulk lines at the curb and corners, and photograph any label or part number you can reach. That’s useful information and it costs nothing.

Where it goes wrong is the tear-out and the waterproofing. A failed membrane means removing tile to reach it, and redoing a shower pan or a wet-area membrane correctly is not a weekend job – it’s a sequence of priming, lapping, and curing that has to be right the first time, or you’re back to the same leak in a year. If you’re seeing soft subfloor or water in the wall, stop and get eyes on it. Our technicians have up to 28 years of experience with this work. Call (888) 427-1810 and we’ll tell you honestly whether you’re looking at a repair or a replacement.

FAQs

Need Construction help nationwide? Licensed & insured · free written estimates
Call (888) 427-1810
Local Service Coverage

Request a Free Estimate in Lancaster

Tell us what you need - Barrett & Sons Construction Lancaster responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Send a Text
Call Now - 24/7 Dispatch