Bathroom remodeling
Kitchen remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
CertainTeed Bathroom Remodeling: The Lancaster Owner’s Guide
Barrett & Sons Construction Lancaster installs CertainTeed-compatible bathroom remodeling across Lancaster, and a full bathroom remodel in this market typically runs $9,000 – $28,000 depending on tile scope, shower or tub conversion, vanity work, and whether the plumbing wall has to come open. This is planned work, not emergency work, so we schedule your free estimate and walk the room with you before anything gets ordered. Most Lancaster owners find the failure the same way: a slow dark line at the shower pan edge, grout that won’t stay put no matter how many times it’s patched, or a little soft spot in the subfloor that shows up when they kneel to clean the baseboard.
CertainTeed makes a range of building products that end up inside a bathroom envelope, and the ones we see fail in Lancaster homes are usually the tile backer and moisture barrier side of the system rather than the finished face. Once water gets behind the field tile, the finished surface is just the last thing to show it. Here’s what to check, what it costs, and when to stop poking at it yourself.
Key Takeaways
- A typical Lancaster bathroom remodel runs $9,000 – $28,000; a small bathroom sits at $5,000 – $12,000.
- CertainTeed backer and membrane products are specified by thickness, sheet size, and substrate; matching the right board to your existing assembly matters more than the brand name on the face.
- Water damage behind tile is almost always invisible until it reaches the floor below or the wall in the next room.
- We’re an independent contractor, not affiliated with CertainTeed, and we source the correct replacement materials for your assembly.
Which CertainTeed Models This Applies To
CertainTeed’s bathroom-side products aren’t a single part with a single model number the way a faucet cartridge is. The relevant lines are cement backer board (sold in 1/4-inch, 1/2-inch, and thicker panels and in common 3-foot by 5-foot and 4-foot by 8-foot sheet sizes), fiber-cement siding-adjacent panels sometimes reused in wet areas by owners who shouldn’t, and moisture-resistant gypsum board used on bathroom walls outside the wet zone. If you’re trying to match a product already in your wall, pull the manufacturer stamp off a scrap or a cut edge, note the thickness, and measure the sheet. That stamp is the only reliable identifier; the color of the board alone tells you very little.
The real compatibility gotcha in Lancaster isn’t the brand, it’s the assembly. A 1/2-inch backer board over 16-inch stud spacing behaves differently than a 1/4-inch panel over a solid substrate, and a moisture barrier lapped the wrong direction will fail no matter whose logo is printed on it. On the OEM-versus-aftermarket question: for backer board and membrane, a quality equivalent from a known manufacturer performs the same job at the same thickness, and we’ll tell you plainly when the equivalent is the smarter buy and when it isn’t. For anything that’s part of a manufacturer’s system with a published warranty, staying inside that system is usually worth the small premium. We also install KraftMaid, Cambria, and Silestone in bathrooms where the vanity and countertop are part of the same job.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your CertainTeed Bathroom Remodeling Is Failing
These are the five failures we get called about most in Lancaster, and what’s actually happening underneath.
- Grout cracking along the shower floor or the first course of wall tile. The substrate is moving, usually because the board wasn’t fastened to spec or the framing behind it has taken on moisture. Re-grouting hides it for a season and then it comes back.
- A soft or hollow-sounding spot when you press the floor near the shower or tub. Water has reached the subfloor and the backer is no longer bonded to anything solid. This is the one to stop ignoring, because floor framing in a small Lancaster bathroom is often closer to grade than owners expect.
- Dark staining or efflorescence at the pan-to-wall joint. The pan liner or the waterproofing membrane has failed at the transition, which is the single most common leak point in a tiled shower. It rarely shows on the surface first.
- Paint bubbling or a musty smell on the wall behind the shower. Moisture is passing through the assembly into the adjacent room. This tells you the barrier has already been compromised for a while.
- Tiles popping loose or lippage appearing where it was flat. The thinset has lost its bond, usually from repeated wet-dry movement on a board that wasn’t rated for the wet zone. Once tiles start lifting, the whole field is suspect.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s what bathroom work runs in Lancaster, priced as installed ranges rather than parts-plus-mystery-labor. Every estimate is written line by line, and every change order is issued in writing before work moves.
| Scope | Installed Range (Lancaster) |
|---|---|
| Full bathroom remodel | $9,000 – $28,000 |
| Small bathroom remodel | $5,000 – $12,000 |
| Walk-in shower installation | $4,500 – $12,000 |
| Tub-to-shower conversion | $3,500 – $10,000 |
| Shower replacement | $3,000 – $8,500 |
| Bathroom vanity installation | $800 – $3,000 |
The range is driven by how much demolition reveals. A shower that comes apart cleanly and shows sound framing lands near the bottom; one where the subfloor has to be cut out and the plumbing wall opened lands near the top. Materials sit inside those numbers, and if a tile or fixture allowance runs short, you hear about it in writing before we buy, not on the final invoice. Permits are pulled and inspections signed on every eligible job. Every completed bathroom is backed by our written 90-Day Done Right Promise, and our technicians have up to 28 years of experience with this kind of assembly work.
DIY or Call Us?
What you can safely check yourself: press the floor around the shower and tub for soft spots, look for cracked grout or caulk lines that reopen within weeks of repair, check the ceiling below the bathroom for staining, and confirm the bathroom exhaust fan actually moves air by holding a tissue to the grille. Those four checks tell you whether the problem is cosmetic or structural, and none of them involve opening a wall.
Where DIY goes wrong: pulling tile to “see what’s under there” without a plan for what happens if the waterproofing is intact, and re-grouting or re-caulking a joint that’s failing because the substrate is moving. You’ll spend a weekend and a few hundred dollars to hide a leak that keeps running behind the wall. Water damage inside a bathroom assembly is not a weekend project, and the longer it sits, the more of the floor framing it reaches. If your checks point to anything soft or stained, call us at (888) 427-1810 and we’ll schedule a free estimate.
FAQs
A properly built tiled shower assembly typically lasts 20 to 30 years in Lancaster’s dry climate, and the failure that ends its life is almost always the waterproofing layer, not the tile. Lancaster’s low humidity actually helps here, but the swing between dry summers and winter rain means any moisture that does get behind the tile has less chance to dry out than owners assume. If your shower is past 20 years and you’re seeing cracked grout that keeps coming back, it’s worth an inspection.
Sometimes, yes. If the damage is confined to a small area and the substrate behind it is sound, a targeted repair of a few square feet of tile and backer can hold for years. If the failure is at the pan-to-wall joint or the floor feels soft, a repair is a cosmetic patch over a structural problem, and you’ll be back in the same spot within a year or two. We’ll tell you which one you’re looking at, and we won’t sell a full remodel when a repair will honestly do. Call (888) 427-1810 for a free second opinion on any written estimate you’ve already received.
A shower replacement typically takes three to five working days once materials are on site, and a full bathroom remodel runs two to four weeks depending on scope and inspection scheduling. Tub-to-shower conversions usually land in the four-to-seven-day range. Delays almost always come from materials ordered late or from a permit inspection that needs a re-visit, which is why we pull permits up front and confirm the schedule with you in writing.
We identify the existing assembly from the manufacturer stamp, board thickness, and substrate, then specify a replacement that matches it and meets current code for a wet area. We don’t carry stock and we don’t claim to; materials are ordered for your job from suppliers we’ve worked with for years, and the brand and specification are written on your estimate so you can look them up yourself. If a supplier substitutes an equivalent, you hear about it before it’s installed.
Yes. Permits are pulled and inspections signed on every eligible job, and the inspector works for you, not for us. That’s a big part of why we insist on it. If a previous contractor told you permits were optional for a shower or tub conversion, that’s worth knowing before you sign anything with them.
Not without your signature. Every scope, every allowance, and every price change arrives as a written change order before work happens, because an allowance that isn’t on paper is a surprise waiting for a date. If demolition reveals something nobody could see, we stop, write it up, and get your approval before a single nail moves. Our standing offers include $40 off any repair over $200, a free second opinion on any written estimate, no trip charge inside the county, and a permanent 10% senior and veteran discount.
We’re an independent contractor, not affiliated with CertainTeed, and we install and repair bathroom assemblies across Lancaster and the surrounding communities. Calls are answered by a live person 24/7, and our crew members are background-checked. If your bathroom is telling you something’s wrong behind the tile, call Barrett & Sons Construction Lancaster at (888) 427-1810 to schedule your free estimate.
Written by the team at Barrett & Sons Construction Lancaster, serving Lancaster and nearby areas.