A Barrett company - serving Lancaster, CA

Tremron Roofing in Lancaster, CA

RoofingRoofing
Kitchen remodelingKitchen remodeling
Bathroom remodelingBathroom remodeling
Home additions & ADUHome additions & ADU
Windows & doorsWindows & doors
Driveway & paversDriveway & pavers
FenceFence
Every visit starts with

Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled

We have financing partners for your dream remodel*On approved credit; ask us about your options
Get your free estimate

Tremron Roofing: The Lancaster Owner’s Guide

We install and repair Tremron-compatible roofing across Lancaster, and a full roof replacement here typically runs $8,000 – $20,000, depending on the size and pitch of your home. Smaller repairs, like a lifted course or a cracked field shingle, fall in the $400 – $1,800 range, and we can usually get an estimator out to look at it through the week. Tremron is best known for pavers and hardscape products, so most owners who call us about “Tremron roofing” are dealing with the underlayment and drainage layer beneath a Tremron-capped patio cover, a flat roof edge detail, or a covered breezeway – not a full Tremron shingle roof. That distinction matters, because what fails first is almost always the membrane and flashing, not the finish layer.

Call (888) 427-1810

The way most Lancaster owners discover the problem is a stain that shows up on a ceiling a few days after a wind event, or water pooling on a flat cap that used to shed clean. Call it a drainage failure and you’ll be closer to the truth than most contractors would lead you toward.

Key takeaways

  • Installed roof replacement in Lancaster: $8,000 – $20,000. Roof repair: $400 – $1,800.
  • Tremron’s flagship roofing-grade products are its paver and flat-stock lines, so the actual roofing layer on your home may be a membrane or underlayment system, not a Tremron-branded shingle.
  • Heat and sun exposure in the Antelope Valley age flashing and sealant faster than owners in cooler climates expect.
  • We’re an independent contractor, not affiliated with Tremron. We install compatible materials and repair what’s there.

Which Tremron Models This Applies To

Tremron makes two product families that show up on roofs and roof-adjacent structures in Lancaster homes: its paver series (Olde Towne, Venetian, and the larger Mega Olde Towne line) used on roof decks, patio caps, and covered breezeways, and its flat-stock concrete and manufactured stone products that get used as coping and fascia on built-up roof edges. If you have a Tremron-branded shingle roof, we haven’t seen one, and we’d be cautious if somebody tells you that’s what’s up there. What we do see is a Tremron paver deck or cap laid over a roofing membrane that has aged out.

To identify what you have, measure a full paver course and note the color code stamped or molded on the underside – Tremron paver lines run between roughly 2⅜” and 2¾” thick depending on series, and that thickness tells you which system your flashing and edge metals were built around. Match it before you order anything.

The OEM-vs-aftermarket call is straightforward on Pavers: genuine Tremron replacement pavers match the color and dimension of what’s already there, which matters if you’re replacing a single course or a corner. Aftermarket pavers are cheaper but almost never match a Tremron color lot after a few years of sun fade. For the roofing membrane underneath, we spec a compatible modified bitumen or self-adhered sheet rated for desert UV exposure, and we don’t pretend it needs to be a Tremron-branded product, because it doesn’t.

Explore

Styles & brands we work with

  • Kitchen remodeling
  • Bathroom remodeling
  • Home additions & ADU
  • Roofing
  • Windows & doors
  • Driveway & pavers
  • Fence

Signs Your Tremron Roofing Is Failing

  • Water pooling on a flat cap. Standing water after a rain means the drainage slope has flattened out or a weep point has clogged. Once water sits, the membrane underneath starts to break down from the top.
  • Lifted or rocking pavers. A paver that rocks underfoot has lost its bedding sand or the adhesive under it. That failure almost always traces back to moisture getting underneath.
  • Staining on the underside of a ceiling or beam. Dark rings or a soft spot on the wood below a Tremron deck or cap is a flashing leak, usually at the edge where the cap meets the wall.
  • Cracked or missing caulking at seams and penetrations. Lancaster’s summer heat hardens sealants in a season or two. Hairline cracks you can see are cracks water can find.
  • Visible efflorescence or white powder on pavers. Salt migration from trapped moisture under the surface. It’s cosmetic until it isn’t, and when it stays wet it can lead to spalling.

The one you don’t want to miss is the seam on a flat cap. A five-minute visual check from a ladder after a windy day was how a Lancaster homeowner on our route found a peeling corner before it cost him a ceiling repair.

Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Replacement Cost & What’s Included

For a Tremron paver cap or roof deck repair, budget $600 – $2,500 for a lifted course, cracked paver replacement, or re-flashing at a wall junction. A full re-membrane under a Tremron paver deck typically runs $400 – $1,800 for repair of the roof plane itself. A full roof replacement involving the roof structure but not the paver finish is $8,000 – $20,000 in Lancaster for most single-story homes.

What drives the range on the repair side is access, the number of courses involved, and whether the penetrating moisture has gotten into the sheathing. What we include in every job: written scope before we begin, materials listed by product and specification, permits pulled and inspection signed where Lancaster requires it, and the 90-Day Done Right Promise written on the contract. If a price change comes up mid-job, it arrives as a written change order before we touch anything.

DIY or Call Us?

You can safely check a Tremron roof cap from the ground with binoculars, and you can look at a paver course by walking on it and feeling for rock. You can also look at the flashing site from a ladder if it’s a single-story home and the ladder is on stable ground, but not on the roof itself.

Here’s where it goes wrong. The membrane under a paver cap has to be laid with a proper slope, adhered to spec, and flashed against the wall to shed water. Most failed DIY jobs we repair short-cut the flashing. And on a flat roof edge, water doesn’t fail fast, it fails slow. By the time you notice it, it may already be in the sheathing.

If you’re looking up at a cap that’s lifting, or you’ve got a stain below it, call (888) 427-1810 and let us look. Our technicians have up to 28 years of experience and we’re insured and bonded. When the phone rings, a live person answers – 24 hours a day.

FAQs

Need Construction help nationwide? Licensed & insured · free written estimates
Call (888) 427-1810
Local Service Coverage

Request a Free Estimate in Lancaster

Tell us what you need - Barrett & Sons Construction Lancaster responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Send a Text
Call Now - 24/7 Dispatch